IDF idle jet holder.
Extended.
Idle jet holders, suitable for dual carburettors of the IDF series.
These extended holders allow the replacement of the idle jets with the carburettor installed, and even without relying on service cutouts. The holders can simply replace the existing holders. A 10 mm open-end wrench is required for installation and removal.
These extensions are our preferred choice, and we fit them as standard on all our dual carburettors.
Essential for anyone about to tune their dual carburetors and looking for a hassle-free experience.
The brass turned parts have an overall length of 45.2 mm and are equipped with a fuel-resistant O-ring with dimensions of 4.48 x 1.78 mm. The shaft has a diameter of 3 mm.
Fits Weber IDF and equivalent carburetors.
You will receive a set of 4 jet holders, complete with O-rings
The idle jet holders are designed with an inner diameter to accommodate the largest commercially available jets. If the idle jets fit too loosely, they can be slightly bent open at their ends.
Fuel Connection 6mm.
The right diameter.
This fuel inlet fitting for IDF carburetors is made from 100% brass and replaces the standard 8mm fuel inlet.
The fuel inlet is designed for engines up to 90hp. The mechanical fuel pump, if in good condition, can continue to be used. The major advantage is that there is no need to modify the line system from the tank to the carburetors, or to resort to any adapters. This reduces the risk of leaks, as every connection point can become a potential leak.
When ordering our carburetors, there is an option to choose between the standard connection and this Fritz Fahrkraft development.
The brass turned parts have an overall length of 37 mm. The shaft has a diameter of 6 mm.
Fits Weber IDF and similar Carburetors.
One set (2 pieces) of fuel inlets
Manufacturer's details (information obligations under the GPSR Product Safety Regulation):
Fritz Fahrkraft GmbH
An der Alster 6
20099 Hamburg
www.fritzfahrkraft.de