IDF idle jet holder.
Extended.
Idle jet holders, suitable for dual carburettors of the IDF series.
These extended holders allow the replacement of the idle jets with the carburettor installed, and even without relying on service cutouts. The holders can simply replace the existing holders. A 10 mm open-end wrench is required for installation and removal.
These extensions are our preferred choice, and we fit them as standard on all our dual carburettors.
Essential for anyone about to tune their dual carburetors and looking for a hassle-free experience.
The brass turned parts have an overall length of 45.2 mm and are equipped with a fuel-resistant O-ring with dimensions of 4.48 x 1.78 mm. The shaft has a diameter of 3 mm.
Fits Weber IDF and equivalent carburetors.
You will receive a set of 4 jet holders, complete with O-rings
The idle jet holders are designed with an inner diameter to accommodate the largest commercially available jets. If the idle jets fit too loosely, they can be slightly bent open at their ends.
Manufacturer's details (information obligations under the GPSR Product Safety Regulation):
Fritz Fahrkraft GmbH
An der Alster 6
20099 Hamburg
www.fritzfahrkraft.de